I got the 6 Pos chip installed today and its supposed to have the nvk4 programs on it but I dont think it does. I got stock, hi idle, 50,75,100,140 and it seems to be pretty quick but doesn't seem to be as fast as it was when I had my edge attitude on it. Also when its turned all the way up and Im cruising at hwy speeds 55mph plus and I stab the gas to the floor it downshifts for like a half a sec and seems like it goes right back into overdrive because its really sluggish and does like a torque roll from overdrive and def doesn't take off like it did with my edge on it. Also the shifts are EXTREMEMLY hard and takes like 1.5secs to shift.. Does the computer take time to learn or anything?
2 HOURS LATER
I got the chip burned by Ts Performance there self. I was driving the truck around and had it on the 100hp setting and stabbed the gas and the truck took off and then just fell on its face... I slowed down to dead stop and gave it gas and the truck doesn't really want to move at all. You floor it and it just revs up and slowly starts to climb mph. It wont down shift when going it just just pegs out the rpms in that gear and slowly climbs mphs. It takes FOREVER to get to 45mph. Its not the motor because you put it in neutral and rev and it revs and sound fine. I figured the programmer might of messed up so I turned the truck off and cranked it back up and same thing. So I turned the knob to stock and still same thing. I even took the chip out of the computer and its still doing the same thing. Did the chip mess my tranny up? Because My tranny was fine early today before I put the TS on there. My tranny showed no signs of messing up. Now that I put the TS on there its all messed up now. I can't even keep up with traffic.
2 HOURS LATER
I got the chip burned by Ts Performance there self. I was driving the truck around and had it on the 100hp setting and stabbed the gas and the truck took off and then just fell on its face... I slowed down to dead stop and gave it gas and the truck doesn't really want to move at all. You floor it and it just revs up and slowly starts to climb mph. It wont down shift when going it just just pegs out the rpms in that gear and slowly climbs mphs. It takes FOREVER to get to 45mph. Its not the motor because you put it in neutral and rev and it revs and sound fine. I figured the programmer might of messed up so I turned the truck off and cranked it back up and same thing. So I turned the knob to stock and still same thing. I even took the chip out of the computer and its still doing the same thing. Did the chip mess my tranny up? Because My tranny was fine early today before I put the TS on there. My tranny showed no signs of messing up. Now that I put the TS on there its all messed up now. I can't even keep up with traffic.
Last edited: