THEFERMANATOR

07 chevy swap 8.1
I have another one setup going in a 07 Chevy took out the 8.1 put in 12v be pump. I'm using the the throttle body to operate the injection pump by using a cable. It work great for reving the rpms up but if you start to drive it get 20 ft are so. The throttle goes erratically rpms go up a d down. I made a mechanically operated foot control off of the throttle actuator and took the cable off the lever on the throttle body. We can drive it but it inconsistencies in the shifting because the throttle body is still trying to hunt up and down. My question is do you know of a way to settle the throttle body down. The throttle body is the tps. I don't have the mass airflow sensor plugged in the harness just remember that now. Don't think that will solve the problem. I had no.when we talked that was a few phones I can send pictures. No wiring was modified for this . Have good tps % just jump with the throttle body.

Dale
314-691-4532

I jus had a quick question, You've commented on a couple of my posts before and I'm still having the same problems which I'm going to finally attempt to resolve . I have an 06 allison with a 5 speed valve body and nsbu installed behind a cummins and my question is what which transforming kit would I use for the valve body I know the trans guy installed the 04-10 valve in the pump shich I hope is right but I figured I'd need the shift kit for a 5 speed valve body. Please forgive me I have been tracing down a ghost for 6 months now I'm just trying to retrace all my steps, I'm going to also get a new valve body and send my converter back to get fixed because there's aluminum in the fluid