Looking for a ported Cummins head
Dropped a valve seat on my current head and I'm looking for something better than stock but not a full race head
|
Probably need to know which head you are wanting 12v, 24v, and etc.
|
If you're wanting a 12v head I have one you'd probably like.
|
You should probably put it in the right subforum too...like maybe the looking to buy.
|
I know of a 5.9 CR with ZZ Fab and 1mm+ valves.
|
How much Broaner and what year cr head?
|
5.9 CR. So 03-07. No difference between years of 5.9's. I would take $3700 for it. It is fresh. Never been bolted down since it was built up. Built by MHP. Has 103# springs also and fresh everything. Freeze plugs tapped with pipe plugs. Comes with 3.5" boost tube off the zz fab
|
Quote:
|
Aren't there issues with bore size and oversized valves on 5.9 motors? Just was wondering out of curiosity
|
Sorry Insane I missed this. I have no flow data. It is MHP work though.
Oversized valves need a .020 overbore on a 5.9 but this is going on a 6.7 so no issue. I would still sell it to free up cash but I'm extremely firm on the price. |
The zz fab plenum would allow the use of a 6.7 fuel rail right? Thinking about this for my '08
|
Yes provisions for both rail configurations on the ZZFab
|
$3500 shipped. Just had a development on my build and decided I don't need it. Turns out I've been running a 80/83/1.1 as a primary this whole time. Knowing that changes my whole perspective.
|
All times are GMT -5. The time now is 10:50 AM. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2024, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com