Track bar problems

[24vppump59]

I have a 2nd gen that I cut 2 full coils out of the front and running 2 leafs in the rear with caltracs, my question is what are you guys doing about the track bar situation in the front. All of the adjustable track bars that I have found are for adjusting for lifted trucks but have had no luck finding any for lowered trucks unless I'm miss reading something. Any input would be appreciated.

 

[Levi_plummer]

The grinch had a heim joint at the bottom of the track bar and a lukes link on the top.

 

[SPEEDSHIFT]

Just have one built. Any good off-road shop should be able to build you one pretty easily.

 

[Cflanery88]

Probably should just make one. Unless it’s possible to cut the stock one, figure out how much shorter it needs to be, buy a piece of tube for a sleeve that has a large enough I.D the trackbar ends will slide Into it, and then weld it back together.

 

[SPEEDSHIFT]

You could cut the stock bar and drill and tap it for a heim joint. I wouldnt weld to the stock cast bar.