Homemade centrifuge out of torque converter

Shortbedguy

New member
Joined
Apr 24, 2012
Messages
255
4h44jm.jpg


2012-04-26_15-55-50_521.jpg
 
I'm getting a little vibration when full I'm thinking about using the smaller torque converter
 
could be that with weight of oil in it that the lower bearing isn't quite rigid enough? would it be possible to extend the shaft through the top and run braces to the sides of the outer tub. with a top bearing so the shaft is supported on both ends.
cool idea though
 
Any updates on this? Looks like a great alternative to dropping $$$ on a centrifuge
 
Back
Top