OTC ball joint press

M

muz

New member
Joined
Feb 10, 2009
Messages
174
Can anyone give me the part number for the OTC press that will work on 2gen rams with dana 60's?
 
MUZ, is this just a once or twice used tool? Or do you plan to crank these BJ's out and make some money? The problem with the OTC style kits, is you need 6 pairs of hands to hold all the adapters. The Snap-On BJP1 all locks together. It's a ton more money, but you'll pound them in and out like no tomorrow with it. It also has a flat spot to put in a vice to bring your work piece to the bench.

https://store.snapon.com/Ball-Joint-Presses-Set-Master-Ball-Joint-Universal-Joint-Press-22pc-P644058.aspx
 
LORDDiESEL said:
MUZ, is this just a once or twice used tool? Or do you plan to crank these BJ's out and make some money? The problem with the OTC style kits, is you need 6 pairs of hands to hold all the adapters. The Snap-On BJP1 all locks together. It's a ton more money, but you'll pound them in and out like no tomorrow with it. It also has a flat spot to put in a vice to bring your work piece to the bench.

https://store.snapon.com/Ball-Joint...Joint-Universal-Joint-Press-22pc-P644058.aspx
Click to expand...



I agree! The snap-on press is the sh*t, hands down but does cost a good coin.
 
It's not going to get a huge amount of use, the Snap on kit here comes in at $920... Do any of you guys know the part number of the Snap on adaptors I would need to do just the ball joints? as buying the frame and just the adaptors I need would be affordable for me
 
You must log in or register to reply here.
Back
Top