BigHemi02
New member
- Joined
- Sep 1, 2011
- Messages
- 164
the ppump 24v is in, has a dodge 47rh. motor harness is basically done.
issues i have is how to hook up the cam signal? i have the crank on the front with the DCS kit, right now cam plug goes no where, and i dont have an adapter plate with the fancy cam adapter destroked sells.
also, PATS is giving me fits, whats the cheapest programmer i can use to show the emissions and all that deleted as well?
where can i get a trans diagram to i can ohm out the trans temp wire, NSS ground out, etc?
truck will start and run with the starter wire jumped, but i just need to wrap up the wiring and make it normal.
issues i have is how to hook up the cam signal? i have the crank on the front with the DCS kit, right now cam plug goes no where, and i dont have an adapter plate with the fancy cam adapter destroked sells.
also, PATS is giving me fits, whats the cheapest programmer i can use to show the emissions and all that deleted as well?
where can i get a trans diagram to i can ohm out the trans temp wire, NSS ground out, etc?
truck will start and run with the starter wire jumped, but i just need to wrap up the wiring and make it normal.