NakeDiesel
Smoke'n in the Mud
- Joined
- Jan 20, 2010
- Messages
- 1,116
Got all the fluids filled up on the truck, at least till I can start it and check the final trans level. Ordered all the piping and more vband pieces to build new piping and exhaust stack for the truck, just waiting on them to come in. While I'm off this week and next, been working on building the outer gates for the corral. Got one finished and in place and another one built. Still need one more big gate and then a small 3' gate for loading on trailers. The big gates are just under 10' wide and 5' tall. Had to get creative getting it in place by myself with a couple of ratchet straps and a level. Gates are made out of 2" pipe along the outside, with 1 1/2" pipe on the inside and then 4 sucker rod horizontal fillers.
Also been doing some 3d models, one as a test run for plaques for a poker chip run our riders chapter will be holding this spring and another set of models for a friend that wants to use them as stamps for paint I think.
Also been doing some 3d models, one as a test run for plaques for a poker chip run our riders chapter will be holding this spring and another set of models for a friend that wants to use them as stamps for paint I think.