Holset/Cat compound turbos

RustyPanda

New member
Joined
Apr 9, 2018
Messages
12
Hey guys I am hoping to get some help from the turbo gurus of compd. So currently I have a ve 12 valve with h1c 12cm waste gated turbine housing . Drilled through divider. Injectors undecided . Just recently I picked up a Caterpillar turbo for twins with specs as follows

Compressor: 69mm small side and 94 mm large side 0.87 A/R

Turbine: 82mm large side 76 mm small side 1.28 A/R

Can't seem to find any number associated with the turbine housing side . Here are some pictures

Only real number stamped into the turbine housing is F2A33 . If the housing is 33cm^2 that would be atrociously large from my understanding. Side note the housing is also waste gated which is nice .

So assuming the housing is somewhat of a reasonable size what is everyone's opinion as to using it for compounds .

Thanks in advance guys
bdd1ff46181b964ce1a13675514a2031.jpg
fe30514b396ffd6faafc00279a6b501d.jpg
3f72693dc3fc2a971a0601b502cff858.jpg
d93222c562bdf787fa6bcccb78b2fe69.jpg
18f7f2ad80d30b6fe9f03b0781e7bd94.jpg


Sent from my SM-A530W using Tapatalk
 
Looks like, sounds like, a stub shaft GTA42. If it is, that would be a pretty decent turbo for a small set of compounds.
 
Sorry I just realized that last picture is awfully blurry the part number is 329-9987

Sent from my SM-A530W using Tapatalk
 
I second, GTA4294 from an Acert.

Zach Faylor can tell you all about it.
I have one also I can't seem to sell.

Sent from my XT1575 using Tapatalk
 
It will not be worth your while. Won't flow near what other gta42 turbochargers will, it will spool much slower with the heavy titanium compressor and it is a complete oddball on all of the flanges. You will have to have custom flanges made or make some for every part of it. The icing on the cake is that is a ball bearing unit. They are unreliable and expensive to replace. I just don't see any value in messing with it.
 
I have a plasma table so flanges aren't a problem . No shaft play but needs new oil seals so I will give Cat a call

Sent from my SM-A530W using Tapatalk
 
It is ball bearing. You wont find "oil seals" for it. CAT is the last place that will sell you parts for it and a new CHRA will be upwards of $1500 from most dealers.
 
@zfaylor you were totally wrong I phoned my local finning dealer and the nice parts guy told me i could buy every individual part in the turbo it just comes pre assembled for the low low price of roughly 6000 dollars haha

Sent from my SM-A530W using Tapatalk
 
Back
Top