BD Iron Horn kit

D

Diesel92

New member
On the bd iron horn kit with the s300sxe, does any one know what exhaust housing they are using for this kit on the sxe turbo and what outlet flange is on it? How are the getting the stock cast elbow to fit on to the s300?
 
The flange is machined for your stock elbow. Just remove the tiny alignment pin, but it up and clamp it. I can't remember the exhaust housing size, but probably a .90.
 
i just went with a s366sxe with a 70 mm turbine and 1.00 ar housing and built my own second gen swap with a steed speed. thank you for the reply's though.
 
That should be a good setup. The iron horn kits are good for people not caring to 2nd gen swap, but need to get rid of the VGT.
 
You must log in or register to reply here.
Back
Top