Boxerdiesel
New member
Hello,
I have a Honeywell turbocharger on my workbench that I have been scratching my head more than usual to get a signal out of it.
Most of the time the vgt position sensors are hall effect with 5v, gnd and signal where signal is a value that changes depending of shaft position from 0 to 5v
But that particular sensor gives me nothing...
I tried to get resistances and move the shaft. Nothing and I hooked it up to tlmy test bench with 4.7K♧ resistance but still nothing.
The sensor say Honeywell CTS ..
Do anybody have an idea?
Thanks
Greg
I have a Honeywell turbocharger on my workbench that I have been scratching my head more than usual to get a signal out of it.
Most of the time the vgt position sensors are hall effect with 5v, gnd and signal where signal is a value that changes depending of shaft position from 0 to 5v
But that particular sensor gives me nothing...
I tried to get resistances and move the shaft. Nothing and I hooked it up to tlmy test bench with 4.7K♧ resistance but still nothing.
The sensor say Honeywell CTS ..
Do anybody have an idea?
Thanks
Greg