ECM Relocate with Billet Tappet Cover?

Rollin Coal02

Rollin Coal02

New member
Anyone running a Billet Tappet cover with breathers with a P pumped 24V? Using the stock tappet cover i just pushed the ECM to the back of the engine and that worked fine. Now the breathers will be in the way. Anyone found a good way to mount the ECM with this setup? PFA
np4nGMP.jpg
 
Last edited:
I took a piece of angle iron and bolted the ecm on that and then used the 2 bolt holes above the motor mount to secure it to the block
 
I've used longer bolts or threaded rod and spacers to mount the ecm over the vent box. Obviously with your set up it would need 90 degree fittings for the vents, but its doable. It would hang kinda far out there with that breather setup.
 
I welded angle to the frame and flipped it around plenty of slack on the harness and got it out of the way
74bc16eee297249797441def73ebd063.png
52918408155b32c9fe70243f077a5a62.png
9458db66f5f27fe78474b76b17d79e65.png



Sent from my iPhone using Tapatalk Pro
 
You must log in or register to reply here.
Back
Top