Well the spacer was there I always set it up with a 1/8 drill bit on the od clutch pack. It turned out the one way rollers were rolling in both directions! Seems I did something wrong there but not sure what! The plastic retainer had a couple squish marks on it is all I could find when I turned the roller by themselves it locked properly but when I dropped the planet gear set in it would rotate in both directions. I replaced that assembly and it works perfectly! FINALLY GOT IT AFTER A WEEK OF AGONY!
__________________
E.D. 66-74-091, T-4 exhaust, 2 Micron filter pre CP3, EFI, S&B intake, ARP 625 head studs, 182-214 Hamilton Cam,springs and push rods,40% injectors, Banks Intercooler, T&C CP-3 & PRV, Built
48RE, 5" exhaust,Carrillo rods, Pacbrake!
|