Cloverleaffarm
Member
- Joined
- Jun 4, 2009
- Messages
- 777
been running a pair of HID retro-fitted lamps since May ish with no issues. Mid-September my low beams began to flicker on and off when the trucks running, just like these trucks do when you don't run a anti-flicker setup. I have ground off the paint around my ground points and put zip ties around all connections.
The issue is only affecting low beams, not high beams.
Running the below items through Lightwerkz.net
Mopar Spec harness
https://lightwerkz.net/collections/wire-harnesses/products/mopar-spec-h13-9008-bi-xenon-harness
Ballasts
https://lightwerkz.net/collections/hid-systems/products/amp-hyluxtek-hylux-2a88-35w-canbus-ballasts
The ballasts are the only things left that I didn't swap out. don't know if that could be the culprit or not?
Lightwerkz customer service sent me a new Harness and it didn't change the problem.
has anyone seen an issue like this? electrical BS is my weakest and least favorite item to deal with.
The issue is only affecting low beams, not high beams.
Running the below items through Lightwerkz.net
Mopar Spec harness
https://lightwerkz.net/collections/wire-harnesses/products/mopar-spec-h13-9008-bi-xenon-harness
Ballasts
https://lightwerkz.net/collections/hid-systems/products/amp-hyluxtek-hylux-2a88-35w-canbus-ballasts
The ballasts are the only things left that I didn't swap out. don't know if that could be the culprit or not?
Lightwerkz customer service sent me a new Harness and it didn't change the problem.
has anyone seen an issue like this? electrical BS is my weakest and least favorite item to deal with.
Last edited: