Quote:
Originally Posted by Hurley
Oh, I meant what the controller monitors to manipulate the VB - TPS, engine RPM, Vehicle speed, etc.
|
APPS and all the factory transmission sensors. Pressure, temp and speed sensors.
Quote:
Originally Posted by CorneliusRox
So this is a stand alone controller where you would unhook the connector from the PCM correct?
Then does it control OD, and lockup, along with controlling your gear with only the governor solenoid?
|
Correct. No
PCM is needed or wanted.
Quote:
Originally Posted by 24vriviera
Dang I wish I had a need for this in the car, but mine currently works so well!
|
Me too!
Quote:
Originally Posted by biggy238
I would imagine it utilizes all of the circuits available to the OE Controller, including the governor and tcc solenoid.
I want to know what is being used on the RH valvebodies
|
Correct. An RH is a 6 wire hookup, 3 on the
VB harness and 3 on the speed sensor. It ends up being only a lockup/overdrive controller that monitors vehicle speed and throttle to shift or lockup.