So the exducer tips on this 63.5mm wheel are taller (wider?) than the original wheel and I am trying to figure out the best way to shape this housing.
Originally I was going to do this so that the tips could really "throw" the air into the housing. But then I was wondering if that would cause a low pressure area and velocity issues?
Would I be better off doing something like this?
__________________
49 Willys Pickup. 5600lb. 11.8sec @115mph 1/4. 12 valve. MegaSquirted 47RH. 3.54 posi rear. 35" tires. 64mm HE351ve, S475 (75/96/1.32), A/W Intercooler. AFC mods. 5x16s. 191 DVs, 180 pump. 23*. 85psi.
Build Thread