MaxSpool power to 6000 RPM's Congratulation John Weatherby

Status
Not open for further replies.
we have high RPM grings in Billet 8620 and Cast. We also have them in 55mm and 57 mm mains with lobe lifts up to .435
 
this cam is becoming popular , I spool up 10 8620 steel UGL billets at a time , 5 are spoken for if you need one the lead time is 4 to 6 weeks after these 10 are ground
 
Last edited:
We've try'd 5th 4lo over and over. I've got videos some where. As soon as I come off the clutch it falls on its face. Barely gets off the line in direct It's still snuffing in 2nd on the big end Anything below 4800rpm or so it falls off hard
 
I am surely not an expert in cams but it would seem to me that high amounts of overlap probably aren't the best for a limited air situation.

School me otherwise, eh.

Is the truck in the video a 2.6 truck?
 
Last edited:
Status
Not open for further replies.
Back
Top