Let's see your pullin hitches!!!

heres mine
index.php
 
Last edited:
Kat said:
Blue's is nothing fancy :D
Click to expand...

Where did you find the Loop/drawbar or what you call it?
I´ve tried to find something like that, but havn´t found it!
 
Last edited:
my old one is alot like jw3's but on my new truck i am going to run a rolepan and just run the ring out a slit in the pan, should look prety clean,k i will post some pics
robert
 
hopefully this will work...if not ill have to find a way to adapt a 3" shackle

its all 1/2" thick plate... and it weighs about 65lbs

105644.jpg
 
RedPuller said:
I welded up my own this past weekend. I'll post up the pics tonite after work.

Joe
Click to expand...
Ok, here is my homemade hitch.

Joe
 

Attachments

  • Clevis1.JPG
    Clevis1.JPG
    35.5 KB · Views: 510
  • Clevis2.JPG
    Clevis2.JPG
    34 KB · Views: 329
Sledpuller said:
mech,
Drop that hitch 4" and see what happens.
Click to expand...
Gene I'm going to raise the the reciever up in the frame so the hitch point will be below the reciever. This will change the angle of the hitch point and have less of a lever affect.
 
Here is one posted by a member on another board. It is like several already posted in that it uses the channel section and pintle ring. However he has made a modification to connect to the bumper so that it takes some of the load. Pretty intuitive actually. Just wonder what regulating authorities like DHRA would think about it? I suppose if it ruffled feathers, you could leave the bumper attachment unbolted or completely off.

pulling_hitch3.jpg


pulling_hitch2.jpg


These images don't show it but a bolt goes through that plate and the hole in the bumper for a ball.
 
You must log in or register to reply here.
Back
Top