Cut Injector Tubes

CC12V

CC12V

CompD CNC
Joined
May 2, 2006
Messages
861
I now carry full flow tubes for Third Gens. Brand new Bosch in stock and ready to ship.
I can cut your own personal tubes also. Just send them in.
Joe
361.960.2217
Crtubes1.jpg

cuttubes1a.jpg
 
What do you do different that bosh doesn't? Does the cutting that you do to them better than the bosh?
 
The one on the left is stock. The one on the right is after I cut them.
 
what is to be gained from this, why did bosch make them this way?
 
Do they change the idle of a common rail any? I know of a guy that put some in his cr and it loped pretty bad, but he also had an mp-8 and iv seen them make a truck lope so it could have been that I never did ask
 
Last edited:
I have them in my stock 04.5. Didn't change anything but the power.
 
CC12V said:
I have them in my stock 04.5. Didn't change anything but the power.
Click to expand...

What kinda of difference are we lookin at? Also any concerns with removing the edge filters? Iv been wantin to have some done, I got a spare set layin around I'm just kinda scared of damaging the injectors
 
Last edited:
You must log in or register to reply here.
Back
Top