Boosted Bulldog
New member
Hello Guys,
I did a lot of wrenching today on my 1948 Mack EF 24 Valve swap. My question is can I drop the pan and rotate is 180 degrees and change the sump pick up to the rear? This engine is out of a 1999 FL50 Freightliner. I would gain a ton of room if so.
Thanks,
Brent
I did a lot of wrenching today on my 1948 Mack EF 24 Valve swap. My question is can I drop the pan and rotate is 180 degrees and change the sump pick up to the rear? This engine is out of a 1999 FL50 Freightliner. I would gain a ton of room if so.
Thanks,
Brent