Thread: Pinion Depth
View Single Post
Old 08-10-2015, 05:51 PM   #37
takedown95
 
takedown95's Avatar

Name: takedown95
Title: Too Much Time
Status: Not Here
Join Date: Aug 2011
Member`s Gallery
Posts: 2,841
Quote:
Originally Posted by Supershafts View Post
Don't use usa standard....... they are missing important processes.

Set the pin height with your tool to what the dana spec is then check the pattern, then make adjustments from there.
Don't run the bl as others have said, all that does is create drag, ring teeth will deflect and there will be BIND. I wouldn't even recommend doing less than .005.

Make sure you use a case spreader, learn how to use it, learn how to set the carrier preload so is DOESN'T deflect as much under load and open up the bl, which bl moves up and and down the tooth and what causes ring failures.

.
What processes are they missing?
  Reply With Quote