Looking for a ported Cummins head

Dww1999

New member
Joined
Jul 8, 2015
Messages
3
Dropped a valve seat on my current head and I'm looking for something better than stock but not a full race head
 
Probably need to know which head you are wanting 12v, 24v, and etc.
 
You should probably put it in the right subforum too...like maybe the looking to buy.
 
5.9 CR. So 03-07. No difference between years of 5.9's. I would take $3700 for it. It is fresh. Never been bolted down since it was built up. Built by MHP. Has 103# springs also and fresh everything. Freeze plugs tapped with pipe plugs. Comes with 3.5" boost tube off the zz fab
 
Last edited:
5.9 CR. So 03-07. No difference between years of 5.9's. I would take $3700 for it. It is fresh. Never been bolted down since it was built up. Built by MHP. Has 103# springs also and fresh everything. Freeze plugs tapped with pipe plugs. Comes with 3.5" boost tube off the zz fab

Do you have any idea what the cfm flow rate is on the head and who did the work also any pics?
 
Aren't there issues with bore size and oversized valves on 5.9 motors? Just was wondering out of curiosity
 
Sorry Insane I missed this. I have no flow data. It is MHP work though.

Oversized valves need a .020 overbore on a 5.9 but this is going on a 6.7 so no issue. I would still sell it to free up cash but I'm extremely firm on the price.
 
The zz fab plenum would allow the use of a 6.7 fuel rail right? Thinking about this for my '08
 
$3500 shipped. Just had a development on my build and decided I don't need it. Turns out I've been running a 80/83/1.1 as a primary this whole time. Knowing that changes my whole perspective.
 
Back
Top