2500HeavyDuty
New member
- Joined
- Jan 27, 2008
- Messages
- 17
This Mod works for All the GM pickups IIRC from the years 00-02. I know for a fact it works on 01-02 but correct me if im wrong.
The mod Allows you to have your Low Beam and High Beam headlights on at the same time only when your high beams are switched on.
Disclaimer: If you live in Texas do this mod at your own risk. It is illegal to have more than 4 lights on at one time
1.First you will need a Screw driver, 1/2 inch socket with ratchet, wire cutters/strippers, Scotchlok, Eye terminal, Zip ties, pliers, and Wire. These parts can be purchased at a local radio shack , auto zone, or wallmart if you don't have them on you.
2. Open up the hood of your Beast.
3. Use the socket wrench to remove the Bracket in the corner that is connected to the firewall and fender that is being held in place by four 1/2 inch bolts.
4. With it removed place it in a convenient place.
5. Next remove the cover for the electrical center.
6. Now look over the electrical center and look at the side facing the engine and you will notice two tabs sticking out...
Push down on the electrical center cover and slide the cover over the tabs that stick out (i used a screw driver). After you done that the Electrical cover should be able to come off by pulling straight up on it
The mod Allows you to have your Low Beam and High Beam headlights on at the same time only when your high beams are switched on.
Disclaimer: If you live in Texas do this mod at your own risk. It is illegal to have more than 4 lights on at one time
1.First you will need a Screw driver, 1/2 inch socket with ratchet, wire cutters/strippers, Scotchlok, Eye terminal, Zip ties, pliers, and Wire. These parts can be purchased at a local radio shack , auto zone, or wallmart if you don't have them on you.
2. Open up the hood of your Beast.
3. Use the socket wrench to remove the Bracket in the corner that is connected to the firewall and fender that is being held in place by four 1/2 inch bolts.
4. With it removed place it in a convenient place.
5. Next remove the cover for the electrical center.
6. Now look over the electrical center and look at the side facing the engine and you will notice two tabs sticking out...
Push down on the electrical center cover and slide the cover over the tabs that stick out (i used a screw driver). After you done that the Electrical cover should be able to come off by pulling straight up on it