Home spot free wash

TheBigNasty

Project bish
Joined
May 9, 2007
Messages
5,385
Built this little doo dah. Hydrologic stealth 200 RO into a 65 gal leg tank. Takes about half a day to fill, but can completely wash (pre rinse, soap, rinse) 2 crew cab trucks. Between this and the foam cannon/chemical guys Mr. Pink, it's made a world of difference. Even the plastics look better, without putting shine on them. I'm in it for less than $300, but had the steel and tank sitting around.

51FDC302-57D7-4340-A334-544114715FA4.jpg

5140DA72-1EFD-4FF0-9752-6E903D406BD7.jpg

D3D589D4-6292-4C9F-9551-9199B74877FA.jpg

56499998-3CB4-4B11-A451-FFB4D6465F86.jpg
 
Geez.... 200gal RO is a rough 3:1 ratio. So to net those 200 low tds/stripped gals, you wasted essentially 400gals.

Assuming your on municipalities, then again could be well being Magnolia...?
 
at 2:1 TDS should be well below 10% of incoming water. spots are almost non existent at TDS below 50 . if incoming is 300 , and TDS is less than 30 , you can actually go to a higher production membrane , and make good water faster.
 
at 2:1 TDS should be well below 10% of incoming water. spots are almost non existent at TDS below 50 . if incoming is 300 , and TDS is less than 30 , you can actually go to a higher production membrane , and make good water faster.

Id agree, that's purified bottled water at <10! Hell ozarka water tests at 20ish.
 
Back
Top