79powerwagon
New member
- Joined
- Jul 31, 2017
- Messages
- 328
Im going to be changing the intercooler setup in my 79 and was wondering if anyone had some tips for fabricating charge piping from mild steel. Using a Small miller mig. Have a couple sets of 2nd gen piping to work with.
Now ive done exhaust systems and rigged up some charge piping but it wasnt necassarily pretty. Id like this set to be presentable.
I will likely be making a few pie cuts. Is there a better way to join these pieces than just butting them up? Better to use a 3” od piece to slip inside piping? Man up and buy some mandrel bent stuff?
Now ive done exhaust systems and rigged up some charge piping but it wasnt necassarily pretty. Id like this set to be presentable.
I will likely be making a few pie cuts. Is there a better way to join these pieces than just butting them up? Better to use a 3” od piece to slip inside piping? Man up and buy some mandrel bent stuff?