I made a tow bar out of some left over 2” square tubing I had so I could roll my truck around the housing area on base so it looked like I drove it to prevent getting towed.
Probably 5’ long with a chain on each side for a bit of triangulation and a 2” hitch and a pivot in it to where I could tilt it up against the grille.
I replaced the crossmember under the core support with tubing, put a receiver in it and viola.
It wasn’t built for any highway towing though. I built it so I could put it in the front or back receiver and get it pushed in a garage whichever way I needed.