twins project

12vcummins96

12vcummins96

lovin those huffers
ok guys got a good question
i am running an ext gate on my twins set up. The heater core pipes are hitting the adapter is there any way i can remedy this so i can continue on cause i got frustrated and gave up today:nail:
IMG_20110609_150641.jpg

IMG-20110609-00016.jpg
 
Last edited:
lowes.

soft drawn half inch copper tubing. make your own. or bend and cut your stocker. not everyything is always going to bolt together, somethings going fast means fabrication wether you want to or not.

how about turning wastegate down? (it looks like you are using an ed style adapter spacer.)
 
crackerman said:
lowes.

soft drawn half inch copper tubing. make your own. or bend and cut your stocker. not everyything is always going to bolt together, somethings going fast means fabrication wether you want to or not.

how about turning wastegate down? (it looks like you are using an ed style adapter spacer.)
Click to expand...

ive got some 1/2 copper never thought of that
and yes its a ed gate adapter but no room to bolt it upside down
 
Just run some braided lines and route them where you need to. OR as stated just bend some new copper line to where you need it.
 
trim the hard line down which will pull it closer to the valve covers....

i ran hose from my heater cores thru the fire wall and then trimmed the hardlines to get them way over
 
You must log in or register to reply here.
Back
Top