dieselfreak1466
New member
I recently had the intake shelf milled off my head to run an intake runner but they claimed they could not machine it completely flat. Wondering what guys are doing to to achieve a flat surface across the head.
I'm attempting to build a wicked 12 valve daily drivers. so far I have a 12mm injection pump flowing 540cc of fuel and a 4k gov(but will run 4,300 rpms) a set of 5x18 dual feed injectors all from Northeast Diesel Service of Missouri. A 63/67 HX35 with billet compressor wheel over top of an S475 with a billet wheel and race cover. Ultimate goal is 900-1100 hp.
Any help is much appreciated.
99 Dodge 3500 eclb w/ ZF6 6 speed
I'm attempting to build a wicked 12 valve daily drivers. so far I have a 12mm injection pump flowing 540cc of fuel and a 4k gov(but will run 4,300 rpms) a set of 5x18 dual feed injectors all from Northeast Diesel Service of Missouri. A 63/67 HX35 with billet compressor wheel over top of an S475 with a billet wheel and race cover. Ultimate goal is 900-1100 hp.
Any help is much appreciated.
99 Dodge 3500 eclb w/ ZF6 6 speed