I just got one of these to replace my 60 psi gauge. I hooked it up per the instructions but it will not light up nor will it read boost. I have a good ground and power at the connector. I also have power to the dimmer wire at the connector. Anything else to check or is it the gauge?
Ev2 electronic boost gauge
- Thread starter RAB 38
- Start date
Michael
Comp Diesel Sponsor
Sorry, missed this since I was out of town. Please follow the directions for pressure gauges in these troubleshooting instructions:
http://www.isspro.com/TROUBLESHOOTING%20DOC/ISSPRO_EV2_Troubleshooting.pdf
Please let me know what you find. The most common issue is wires not pressed fully into the orange connector. We have new insertion tools (just arrived last week) that work much better than the old ones, let me know if that is the issue and we can send you a couple of them.
Regards,
Michael Pliska
http://www.isspro.com/TROUBLESHOOTING%20DOC/ISSPRO_EV2_Troubleshooting.pdf
Please let me know what you find. The most common issue is wires not pressed fully into the orange connector. We have new insertion tools (just arrived last week) that work much better than the old ones, let me know if that is the issue and we can send you a couple of them.
Regards,
Michael Pliska