Dana 80 questions

house

house

the Fat kid!
first off what is ring gear bolt tq specs and carrier bolt specs
2nd would you use this carrier with a end looking like this
27299_605528155143_58208478_34585765_2992686_n.jpg

27299_605528170113_58208478_34585768_5892408_n.jpg

27299_605528180093_58208478_34585769_3608483_n.jpg
 
I dont remember the ring gear tq but the four carrier bolts is 80 ft lbs.

I cant hardly tell. It looked at first like it was welded then it didnt look like it. Its just real shiny on my computer. If its not welded you could throw a lockright in place of those spiders and run that.
 
its welded, but look at end cap area the scaring and out of round, but fine where splines are
 
Usually it doesn't ride on the end of the carrier. Rides on the bearings. Looks like there was an axle that snapped inside it.
 
I see what you are talkin about in the second picture but i cant make out the specifics in the third on other than its of the splines. Its just a real close up blurry pic for me. I would say he twisted some axles off before.. Technically it shouldnt hurt anything
 
long story short rear end was making a noise,so got it on jack stands and turned it by hand nd it was binding, so pulled axles out to make sure wasn't a sticking break. Well tore rear end cover to find a piece of weld or old gears stuck between the ring gear and carrier. The previous owner said he just put a axle and ring and pinon in it.
27299_605528090273_58208478_34585754_6416085_n.jpg

27299_605528100253_58208478_34585756_5544394_n.jpg

27299_605528105243_58208478_34585757_6935630_n.jpg

27299_605528130193_58208478_34585761_2779003_n.jpg

too me the ring and pinon look good still
 
House that carrier was in a pro street a couple years back and i know of at least a 2 axle that snaped in it plus one of my own and that last one that you broke
 
You must log in or register to reply here.
Back
Top