Here's my intake that I've been screwing around with. Tapped pushrod bores in block for studs. Never seen it done this way before so I figured I'd try it. Every version of this is always several small bolts around the out side rails of intake but I wanted the biggest volume inside that I could get and blends the smoothest. Have two doll pins to keep it from moving around. Hope it works, have alot of time in the porting of this head.
Attachments
-
pictures from old computer 470.jpg -
pictures from old computer 472.jpg -
pictures from old computer 475.jpg -
pictures from old computer 474.jpg -
pictures from old computer 476.jpg -
pictures from old computer 1169.jpg -
pictures from old computer 1175.jpg -
pictures from old computer 1171.jpg -
pictures from old computer 1174.jpg -
pictures from old computer 1176.jpg
