New ppump sputter
Just installed a new ppump on my truck and on first test drive it sputtered really bad at low rpm but clears up after about 2000 rpm. Looked up some stuff and a lot of people said fuel pressure issue related. I checked and I have 40 psi fuel pressure and I have the upgraded over flow valve. Reset the timing too which is at 22°. This pump has been benched and maxed to flow 600cc and has not been on any other truck before mine so it should be good to go. Could this be too much fuel that I have and I just need to turn down the pump a little? Injectors ran perfect before I replaced the pump so I don’t think they are the problem. Any help would be appreciated. Thanks
__________________
1994 12v Cummins, s366sxe, 5x.018 PDD injectors, 188-220 Hamilton cam, 60lbs VS, Hamilton pushrods and tappets, Maxed 215 pump, Airdog165, NV4500 w/ dual disk south bend
|