Got the 3rd Gen Steed Speed on the truck today.

S

Spooler

New member
Got the new manifold on the truck today. I gained in the 1400 to 1700 rpm range. Lots better spool up. I got just what I was after just like the dyno graphs showed I would get. I'll know how it does under a heavy load in about a month and 1/2 when I go get hay again. I did notice something else nobody has mentioned. I had to move my exhaust back forward 1/4 in. like it was before I put on the my 62/71/13ss turbo. I have a lot more room at the firewall/ auto tranny dipstick area. That was a good surprise.
 
I saw similar results, great midrange power upgrade, helps egts tremendously while towing in that 2000rpm range.

Lavon
 
Crap, haven't checked this thread in a while. I can get a pic. I will upload something tomorrow. Before you get all excited, I have nothing special....LOL Some of these guys on here can eat off their engine while the girlfriend puts on makeup from all the bling...
 
20131005_152711_zpsef5d01bd.jpg
 
Last edited:
You must log in or register to reply here.
Back
Top