Hellmann Dual Ram Intake 12V

CC12V

CC12V

CompD CNC
This is a direct replacement for the stock manifold.Three inch fourteen gauge aluminum tubes.Slight modification needed on injector line clamps to relieve for welds [grind corners].Comes with new gasket and five replacement bolts. $470.00
DualRam1.jpg

DualRam2.jpg
 
Last edited:
I have to ask though, what are the bumps on the valve covers for? Did you have to make room for more valve lift or somthin? Just curious.

George
 
gstanfield said:
I have to ask though, what are the bumps on the valve covers for? Did you have to make room for more valve lift or somthin? Just curious.

George
Click to expand...
I think reason is :headstuds
 
gstanfield said:
I have to ask though, what are the bumps on the valve covers for? Did you have to make room for more valve lift or somthin? Just curious.

George
Click to expand...
My blocks been decked and the studs generaly won't clear your valve covers anyway.I had to drill a hole and weld a cover many years ago.
 
If you give him a call he can probably get to you faster, these intakes are awesome, and with as good as he is at his workmanship you can not ask for better products IMO.
 
You must log in or register to reply here.
Back
Top