nv5600 hard shifting

nv5600 with a south bend dual disc comp clutch.engine not running all speed are smooth.. when engine is running, clutch pedal to the floor and its hard to engage any speed...! got HD hydrolics and i beleive they are good(was working fine with my old clutch single disc ceramic).the 2 disc(feramic) are new. i got like 1'' of freeplay on the clutch fork when i remove the slave...

pilot bearing is new, clutch bearing too. have the clutch fork for DD clutch from south bend... i did not remove the washer under the pivot..

tanks for the help!

Fork in backwards? It seems to happen alot.

maybe.. but i dont think, if i remember right when i have installed i have search for picture on internet to install it the right way.. and i as a sticker on the fork to not install it backwards.. i will remove the trans in a month.. ima check it at the same time..

tanks!

I had a bent/bending fork do that, huge pain to figure out.

Does it go into gear at all? If it does, does it grind?

no grind.. only wont engage!!