JEWING3227
New member
- Joined
- Sep 17, 2016
- Messages
- 77
In the process of a 2nd gen swap on my 05 and will be making the feed and drain lines for the turbo. I'm using 6AN braided on the feed. I have both a M12 - 6AN and a 1/4NPT - 6AN fitting for the filter housing side of the feed. My question is will the M12 - 6AN fitting be sufficient OR should I drill and tap the housing to accept the 1/4 - 6AN? Both fitting I.D's are within a 32nd of each other. Thanks
Sent from my SAMSUNG-SM-G935A using Tapatalk
Sent from my SAMSUNG-SM-G935A using Tapatalk