Recently dyno results

Y

Yzf250racer

New member
Recently dynoed my 09 6.7 cummins. It put down 722hp 1307tq.
ze9u4ydu.jpg
. I am switching to efi live and will get on dyno once efi is dialed in to get a before and after number
 
thank you. I was very surprised on those numbers. over 700 was may goal. the new goal is too see if I can get it over 1000hp on fuel only
 
Your torque is a touch low for a 6.7, but on those motors, keeping the torque down is a good thing when you shoot for 1000 rwhp on the stock bottom end.

Congrats, 700+ is a ton of power for a street truck!!!!
 
I think my low torque is partly because I was running h&s tunning and it dumped a lot of fuel before the turbo could light. But turbo isn't too laggy. With tuning I think I can get the torque up a good bit
 
piston, cam, Carrillo rods, and dual cp3, airdog and intercooler r all sooner or later gonna get ordered and put in. I'm still running my stock lift pump and bottom end and intercooler.
 
700 off the stock lift pump is a feat in itself, force feed that cp3 and I bet you add hp, and torque, no other mods.
 
You must log in or register to reply here.
Back
Top