Trade Race Parts For Street Parts, 12v

BigHemi02

BigHemi02

New member
75/96 1.15 T6 SX4 Turbo, with blanket. has about a dozen runs, like new, powder coated red front cover. - $1000 Shipped

Steed Speed Comp manifold, Angled, Non Gated, T6 - $800 Shipped

5x.022 Injectors, contagious, IIRC, have a few dozen runs - $800 Shipped

Fluid Damper Comp Balancer, NON Belted - $300 Shipped

Trade for S364, t3 manifold (non stock), 5x.014 injectors, .022 DVs (or a step or 2 around there)

selling motor and trans, so either selling roller whole or parting (RCSB '96 4x4)

West Palm, FL
 
runsideways2 said:
I would have to put a pulley on the damper also correct?
Click to expand...

dampner is only about a year old, has a few dozen runs, so only a few hours run time and only a few miles drive time.
part number is 960341 IIRC, Id advise look it up, its comp - so no belt
 
BigHemi02 said:
75/96 1.15 T6 SX4 Turbo, with blanket. has about a dozen runs, like new, powder coated red front cover. - NOT FOR SALE

Steed Speed Comp manifold, Angled, Non Gated, T6 - $800 Shipped

5x.022 Injectors, contagious, IIRC, have a few dozen runs - $800 Shipped

Fluid Damper Comp Balancer, NON Belted - $300 Shipped

Trade for S364, t3 manifold (non stock), 5x.014 injectors, .022 DVs (or a step or 2 around there) GOT TURBO, NEED MANIFOLD, AND 5X14s OR 5X16s

selling motor and trans, so either selling roller whole or parting (RCSB '96 4x4) NOT FOR SALE

West Palm, FL
Click to expand...

Updated.post, lots in motion, apologize for delay
 
I have a set of 5x14's that will only have about 100 miles on them from being cleaned and popped from PDD. They have some needle work too. I just have them in to get my new head gasket seated then going with compounds and bigger injectors. Let me know if you are interested
 
jstaylor954 said:
I have a set of 5x14's that will only have about 100 miles on them from being cleaned and popped from PDD. They have some needle work too. I just have them in to get my new head gasket seated then going with compounds and bigger injectors. Let me know if you are interested
Click to expand...

How much
 
jasonc said:
I have a fmw 467.7/83 and a T4 manifold. Very low use and like new?
In Florida also
Click to expand...

Think that's a bit big for what I wanna go with. Just picked up a super b si gle. Which is too small, but may keep it and go compounds with the 475
 
You must log in or register to reply here.
Back
Top