B boostedve New member Sep 7, 2010 #1 do you think it be possible to spool a 114mm turbo in a set of twins.. p pump motor 12v, its for dragracing what would you use for a top turbo.. its a pt 114mm billet wheel with a t5 1.32a/r exhuast housing.
do you think it be possible to spool a 114mm turbo in a set of twins.. p pump motor 12v, its for dragracing what would you use for a top turbo.. its a pt 114mm billet wheel with a t5 1.32a/r exhuast housing.
S Scorpiont New member Sep 13, 2010 #2 I think that you might have a bit of trouble spinning that one up.
ILLINOISRAM INLINE INSANITY Sep 13, 2010 #5 hell id run it as a single charger just put a custom machined .90 housing for it.
D DRTurbo Turbocharger Engineer Sep 13, 2010 #7 SMOKIN93 said: What size exhaust wheel? I bet you could make it work Click to expand... That turbo is 114mm inducer with 141mm exducer, turbine wheel is 130mm inducer and 111 exducer. Meant for 500-600ci gas motors running 2000+hp as a single.
SMOKIN93 said: What size exhaust wheel? I bet you could make it work Click to expand... That turbo is 114mm inducer with 141mm exducer, turbine wheel is 130mm inducer and 111 exducer. Meant for 500-600ci gas motors running 2000+hp as a single.
JQmile Comp Diesel Sponsor Sep 13, 2010 #8 You'd need lots of fuel to keep the drive pressure up and probably 5K rpm.
Big Blue24 Comp Diesel Sponsor Sep 14, 2010 #10 You could make it work with a wet nitrous kit plumbed into the exhaust housing with a little water injection for extra mass flow in the form of steam!
You could make it work with a wet nitrous kit plumbed into the exhaust housing with a little water injection for extra mass flow in the form of steam!