Advertisement |
|
|
|
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.
|
07-08-2018, 10:42 PM
|
#1
|
Name: winkdemon
Title: Fast, Cheap or Reliable.
Status: Not Here
Join Date: Oct 2009
Location: calgary Alberta
Member`s Gallery
Posts: 248
|
Dyno numbers ?
Looking for some some input. Dynoed my Dd yesterday 1995 12v auto but I think the numbers were low. Just looking for some input on it.
Mod list
Large bowl
Colt stg 3
Hamilton bee hive valve springs
Compounds gt3788r over s480 ats manifold
5x.018 155 angle
Maxed and balance 215 pump 650cc 4k springs timing at 26 degrees
Fass 150 at 45psi
Dual ram banks intake
Bd intercooler
Truck is on 35 inch tall tires and has 4:10 gears
The truck did a 644 hp and 1271 tq. Witch I think is low ?
__________________
1995 cummins 2500 DD stock
1991 cummins race truck still to slow
2003 cummins 3500 tow pig 6.7 powered
|
|
|
07-09-2018, 06:21 AM
|
#2
|
Name: turbo2387
Title: Nipple Fluffer
Status: Not Here
Join Date: Jun 2011
Location: Indiana
Member`s Gallery
Posts: 665
|
Your truck will make 200-2000hp depending on what dyno and who is running it. Its a total racket. Take it down the strip and figure your hp that way.
|
|
|
07-09-2018, 08:26 AM
|
#3
|
Name: CorneliusRox
Title: Seasoned Rookie
Status: Not Here
Join Date: Dec 2012
Location: Detroit, MI
Member`s Gallery
Posts: 4,154
|
X2, do a couple practice launches on an 'off-highway road', hit the track, and use trap speed for the calculator at the top of the page: ( HP Calculator)
That'll get you a better idea.
You setup seems like it should be much more capable than 644hp. Especially since there are pretty bare bones trucks with s466's pushing that.
__________________
Corey - BSME '21 Tesla Model 3 Perf
'22 DMax AT4 2500
|
|
|
07-09-2018, 08:29 AM
|
#4
|
Name: jasonc
Title: Too Much Time
Status: Not Here
Join Date: Nov 2009
Member`s Gallery
Posts: 4,396
|
How much boost pressure did it make on the dyno, compared to what it makes on the street?
|
|
|
07-09-2018, 08:34 AM
|
#5
|
Name: Signature600
Title: THA MAN!
Status: Not Here
Join Date: Aug 2006
Location: Jeffersonville, Ohio
Member`s Gallery
Posts: 11,961
|
How much fuel is the pump set to put out?
You might have too much fuel...
I used to run a 12mm pump that would make 650cc's maxed out, but at 450cc's it ran way better and made 636hp. Didn't have the air for 650cc's with a s362/s480 combo.
Chris
__________________
THANKS TO:
Tim Barber @ TRE Diesel
Jeff Mumau @ Mumau Diesel Service
Rip @ Source Automotive
Don Thuren @ ThurenFab Suspension
Columbus Diesel Supply
|
|
|
07-09-2018, 11:16 AM
|
#6
|
Name: turbo2387
Title: Nipple Fluffer
Status: Not Here
Join Date: Jun 2011
Location: Indiana
Member`s Gallery
Posts: 665
|
Most ive ever done on a dyno was 436 and 980tq with a $3000 injection pump and 62/75 compounds. Did 426 and 960 with the same truck several years ago with a single 62/65 and 5x12’s.
Dont get hung up on those numbers. Get hung up on stomping 100k corvettes stoplight to stoplight with your dog in the passenger seat.
|
|
|
07-09-2018, 07:11 PM
|
#7
|
Name: rdix7991
Title: Grumpy
Status: Not Here
Join Date: Apr 2009
Location: Tifton (aka Notfit), Georgia
Member`s Gallery
Posts: 1,051
|
Not sure if you have thought about this, but even at 45 psi that FASS may not be enough. I would prefer to see 55-60 psi at full throttle for anything over 600 HP.
__________________
2000 Dodge 2500 SB Ext. cab 4x4. SOLD
1996 12V RCLB 4x4
1989 D250 2wd P-Pumped
|
|
|
07-10-2018, 01:33 AM
|
#8
|
Name: SCHMITTY
Title: Not enough time
Status: Not Here
Join Date: Jun 2012
Location: K beach, AK
Member`s Gallery
Posts: 1,177
|
How would you go about getting 55-65 psi at wot ?
__________________
stock 94
|
|
|
07-10-2018, 11:27 AM
|
#9
|
Name: CorneliusRox
Title: Seasoned Rookie
Status: Not Here
Join Date: Dec 2012
Location: Detroit, MI
Member`s Gallery
Posts: 4,154
|
Adjust your pressure relief valve and make sure you've got enough pump.
Some use a pressure regulator or even a high speed check valve with a crack pressure you want ( High Speed Check Valve Pair for use with Waterman Fuel Pump)
__________________
Corey - BSME '21 Tesla Model 3 Perf
'22 DMax AT4 2500
|
|
|
07-10-2018, 10:07 PM
|
#10
|
Name: winkdemon
Title: Fast, Cheap or Reliable.
Status: Not Here
Join Date: Oct 2009
Location: calgary Alberta
Member`s Gallery
Posts: 248
|
The boost was with in 5 psi on the street. Witch is 55psi
I turned the fuel pressure up today it's a at 55psi at wot
The pump is set at 650 right now. But on a wot pull I don't get hot under 1300 egt or have any smoke.
I have went down the track 12.6 at 109 mph
__________________
1995 cummins 2500 DD stock
1991 cummins race truck still to slow
2003 cummins 3500 tow pig 6.7 powered
|
|
|
07-10-2018, 10:09 PM
|
#11
|
Name: winkdemon
Title: Fast, Cheap or Reliable.
Status: Not Here
Join Date: Oct 2009
Location: calgary Alberta
Member`s Gallery
Posts: 248
|
Quote:
Originally Posted by turbo2387
Most ive ever done on a dyno was 436 and 980tq with a $3000 injection pump and 62/75 compounds. Did 426 and 960 with the same truck several years ago with a single 62/65 and 5x12’s.
Dont get hung up on those numbers. Get hung up on stomping 100k corvettes stoplight to stoplight with your dog in the passenger seat.
|
I do that all the time lol
__________________
1995 cummins 2500 DD stock
1991 cummins race truck still to slow
2003 cummins 3500 tow pig 6.7 powered
|
|
|
07-10-2018, 10:11 PM
|
#12
|
Name: winkdemon
Title: Fast, Cheap or Reliable.
Status: Not Here
Join Date: Oct 2009
Location: calgary Alberta
Member`s Gallery
Posts: 248
|
Quote:
Originally Posted by blackmega3500
|
Good thing am a mechanic and not a engish teacher
__________________
1995 cummins 2500 DD stock
1991 cummins race truck still to slow
2003 cummins 3500 tow pig 6.7 powered
|
|
|
07-10-2018, 10:34 PM
|
#13
|
Name: rdix7991
Title: Grumpy
Status: Not Here
Join Date: Apr 2009
Location: Tifton (aka Notfit), Georgia
Member`s Gallery
Posts: 1,051
|
I’d like to see your dyno graph. The TQ number is good, I believe with some tuning you can get 800 out of it. Double check timing and get fuel pressure up to 65 and see what happens.
__________________
2000 Dodge 2500 SB Ext. cab 4x4. SOLD
1996 12V RCLB 4x4
1989 D250 2wd P-Pumped
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -5. The time now is 10:55 AM.
|