New line of sled pulling hitches!

Bobcat698

Bobcat698

Pure Diesel Power
Just picked up a new line of hitches! They are hot right now so there is a 2-3 week wait time, but check em out!

HWBFhitch%20(Custom).jpg

HWDhitch%20(Custom).jpg


Check out our new line here!
 
are these hitches from someone in indiana that just finished the final drawings and etc a couple of weeks ago just wonderin. this hitch looks similar to one i saw on here from him. it looks like a damn sturdy hitch
 
NADM:

Hitch: The hitch must be a receiver-style hitch; reinforcements
are permitted. Reinforcements must not extend forward of
the centerline of the rear axle. Trick hitches are prohibited.
The hooking point must be the rear-most point on the vehicle
and must be rearward of the stock location of the tailgate.
The hitch must be horizontal to the ground and stationary
in all directions. Bumpers may be notched or removed. The
hitch’s height from the ground may not exceed 26 inches. The
hooking point must have a minimum 3.00-inch inside diameter
opening for the sled hook. The hooking point will be measured
to the center of the clevis loop.
 
I hear you Kevin, I guess a lot of associations in Indiana/KY are switching to a larger ID requirement though.
 
Yes that hitch is out of Indiana and I am the guy who that hitch was originally made for. Those hitches are built tough and built for the abuse us pullers put on them. I broke a hitch last year and this was the solution. Thanks Scott
 
You must log in or register to reply here.
Back
Top