Anybody ever seen a nitrous purge hood ornament?
- Thread starter Begle1
- Start date
Mark Nixon
No Savior among the flesh
You're not from this simulated reality, are you? LOL
Mark.
Mark.
Begle1
Active member
Accolades upon you sir!
So it has been done.
How do you think the best way to do it? I know the ornament is hollow. Is it some material that you can silver solder, RTV, JB Weld or just chewing gum a tube into, and then drill holes into the nostrils? Or do you need to get little itty bitty tubes up in there pointed out the nostrils?
Begle1
Active member
Truck is garaged in California and hasn't ran in around three years, currently new engine is installed but missing injectors and an injection pump gear. I should get it running in June on my next visit. I'm about 18 months from buying a house on Maui with a garage, so after I do that and recover my finances a little I'll get the truck shipped out here. Then within five years after that point I might get around to playing with nitrous. (Maui has a 1/4 mile drag strip.)
But I'll post pictures when I'm done, aiming for 2030.
But I'll post pictures when I'm done, aiming for 2030.
