Megabreather

CC12V

CompD CNC
Crankcase ventilation can.Two 3/4" hose inlets, 3/8" hose barb on bottom to drain back into block on third gen Cummins.Can dimensions are 3" diameter by 7" long. No more spotting the ground on high blow by motors.
breather1.jpg

breather2.jpg
 
Last edited by a moderator:
very nice Joe. Question.... not being at my truck to look, is the larger vent tube on the valve cover 3/4" also ? Just wondering about the hose fitting the valve cover tube to the 3/4" tube on your can. Then there's the small tube on the valve cover.... will a 3/4" hose be too big to say attached or is that the one that drains back ?
 
The barb on the stock breather is 1" if you take there adapter off.The oil drain back to the block is 3/8" .
The breather in the pic actually should be labeled for my valve cover. A factory valve cover would only have one 1" barb in this can.The drain on the bottom of the can ties into the factory oil return to the block. In other words this breather system will be self contained.
This will be an option with my billet valve covers at a reduced package price.
Mounting hardware will be a predrilled strap similar to radiator catch cans ,that can be mounted at users discretion.
 
OK, I see that one being for your cover. Will you also be making them for stock covers with the 1" barb ?
 
Back
Top