12V, 6.0L ZF6 Question

I have one of your Street Dual Disk clutches in my Fummins swapped Superduty. I read I may have needed to clearance the throwout bearing sleeve. I didn't do it, but have not yet started the truck. Is it something I should take back apart and check?


I am using Destroked mounts, plate, and flywheel spacer.


Thanks for any help,
Evan Shockey

Pull the Slave cylinder and check to make sure you have free travel in the fork. If you have free travel then no you wont need to pull it back out and clearance it.

Ya,

I don't even have the slave in yet, but I know it wiggles around and moves back and forth at least an inch. Thanks for the help!