Selling the w/a cooler, which is setup to run over the the valve covers on a 12 valve, not sure about other setups. If you want, I can include the cover off the he351cw, that has been modified for this setup. Would love to trade for a stock cover and elbow, if those exist.
Cooler is a precision core (pt1001), I can't remember where the end tanks came from, Garrett possibly. Newsmoke might know, he's the guy that created/fab'd the entire setup. He has a lot of time into this setup. Heat exchanger is from frozen boost. It cracked once at the end tank, but was professionally repaired and pressure tested.
Setup ran well, though I could never get an electric water pump that flowed enough to actually live more than a few months as a daily driver. Right now I have it hooked up on the engine coolant system.
I'd like to start at 800 shipped, for Cooler, exchanger, and the heat shield/dissipator that goes over the valve covers. I'm willing to work out something extra for the compressor cover swap if thats possible. I can also throw in a few fittings if they're wanted.
http://www.frozenboost.com/water-to-...or-p-1063.html
http://www.nolimitmotorsport.com/prod/PTB-054-1001
Setup on the truck, the one in the middle:
You can just see the heat exchanger hiding behind the condenser: