Recent content by 6.0kingranch

I was wondering if using the enamels that are for painting tractors and implements any good for my work truck. I just want the truck to be one color and the paint to last 2-3 years. I have read in a few areas about adding a hardner to bring out the shine and lay the paint better. Has anyone done...

I am wanting to paint my truck and going to try to do it myself. I am sure that I am going to use a single stage paint. Now my question is what is difference between acrylic and enamel single stage paints. The truc is used mostly for work and is by no means a show truck but I would rather have...

I have seen white smoke from my exhuast a few times this week. The truck only does this while there is low boost. Like when driving for a while on the hwy and I coast down, Once I start to excelerate it there will be some white smoke if there is very little boost. I am wondering if this can be...

I tried searching for an article or write up on how to install injectors and came up empty handed. Are there any articles or write ups that you guys know about. I'm sure it's very straight forward unlike the fords. I have alot of free times on hand and would like do it myself. I got a set of...

I am pretty convinced I have a bad fan clutch. The A/C gets hot when the truck is stopped for longer than 5-6 minutes. I don't ever hear it come on when I am driving. My question is what's the best clutch to go with? Should I just go back to a factory replacement or is there an aftermarket...

I am currently fixing the AC on my 95. The previous owners had removed the compressor and never replaced it. I went ahead and ordered all the new new Ac lines, compressor and condensor. I would hate to have to replace the evaporator as well. What do you guys think? I was planning on...

Here is a picture of when I picked up the truck. Here's a shot of the redone sets and door panels. I also had the headliner and floor taken care of.

Class V Hitch 2 1/2' $100.00 plus shipping. SCT Xcal2 $200.00 Shipped. B&W gooseneck hitch $150.00 plus shipping. Firestone Ride-Ride Airbags $150.00 Shipped. Front mount hidden hitch $60.00 shipped Factory Fog lights $50.00 shipped 2' rear wheels spacers $150.00 shipped New in the box Trans...

The truck has no rust and has a cummins recon motor installed less than 90k on it. The truck it self has 329k. the only obvious problem is the mech. pump. I have to pull a string when starting the truck and some times have to shut it of manually. Where's a good place to find the parts to fix...

I am currently looking at a 95 4x4 dually with 300k on the clock. I was wondering if there are any problem areas that I should be looking for. I am not wooried about the tranny as I am sure it will need to be upgraded once I start meesing with things.

I have new in the box transmission cooler and engine oil cooler for 06 6.0. I will take $400.00 for the oil cooler and $300.00 tranny cooler. Prices include shipping to lower 48 states.

Just this morning while towing I noticed popping sounds from the exhuast while the truck down shifted in Tow/Haul Mode. I have never heard this before. Right after hearing this I noticed a slight lose of power. The truck started running fine after that. But now when I rev it up it still pops...

Truck shut off and won't start. It will crank over fine for a moment and then act like the batteries are weak. Checked the DTCs and got this code agian P2284. Need you alls help quick. I am on my back to Miami and stranded out about 30 miles west of Tallahases.

Truck threw this code today. I was cruising on the highway. I cleared it and hope it doesn't come back. P2284 ICP Injector control pressure sensor circuit range/performance A difference in commanded versus actual injection oil pressure was detected.

Anyone ever used this? Never heard of this and stumbled across it on a vendors site. Just curious if it works and is worth using.