Recent content by bluelineranch

so how are you guys and gals running your hookup from the intercooler to your compressor outlet on larger single turbos? I have an s366 now and I've usually been able to stretch things out enough that I don't need to add pipe or more boots but it seems this time ill have to rig up something...

What is the trick for putting the engine into my pickup? When I pulled it out I took the push rods and rockers out and also had to unbolt the motor mounts from the block. Putting it in has been a nightmare, first 3 times I tried sbc sent me the wrong clutch disks so the input shaft was too large...

Hey guys I've been building an engine for what seems like forever now and it appears I have hit my last wall. Cummins Cylinder heads suck! Mine needed valve guides so I sent it in had it magnifluxed and its cracked in 21 places so I bought another used head same story bad guides and cracked...

hey everyone ive got a 99 engine with a bad block has everything but vp44 exhaust manifold turbo and intercooler, let me know what your wanting out of it and ill get you a price, or Ill sell the whole thing whatever works thanks Cody

Hey guys I'm in the process of rebuilding my engine and would like some input, the block has been magnifluxed and is waiting to be bored (had to be .20 over) the crank seems good but the rotating assembly is getting sent off for knife edging and balancing Im studding the mains and using a-1 rod...

hey everyone Im new to the twin turbo thing and in my research Ive found that they arent cheap :lolly: what brand and size s480 would you recommend as a bottom turbo to a 64/12/65 and where would you would recommend getting one for a reasonable price

Smarty SO3 for sale with revo software 550.00 shipped redline performance box software is 2005 i have map adapters from 1998-2002 Let her go for 900.00 Also looking for twin turbo parts 719-2four3-529four thanks for lookin Cody

hey guys wanting to sell my edge comp, Ive seen they are going for around 300 so Ill say 300 + shipping. it works great, harness is complete Its for a 98-2000 pickup, Ive got the data connector for all the years in between.

has any one had this happen? I was putting in my rocker assembly and popped the threads in the cylinder head, the bolt is fine, I threaded another in and cleaned it out only to have it happen again, anyone know a way to fix this? I think I may have to pull the head which sucks cus I just had it...

hey guys im having problems getting my arps installed, put the head on and got studs to the cowl where the troubles began, Ive cut several pieces out of my cowling but the last 2 studs are being a real bastard, i fear anymore cutting because ive already got metal floating around and any more...

hey guys, I started installing some studs today and when I pulled the first head bolt I noticed "water" on it, upon further inspection I noticed that there was a lot of it floating on top of my oil in my head. The problem I've run into is I don't know if its water or coolant, I couldn't catch it...

hey everyone I've got a turbo related question, I just put on a Holset H1E non wastegated turbo, and the sucker will not spool well or hit much over 20 psi my pickup has 150s in it and I'm pretty sure it should be doing better than this, so im looking at a few options 1.chip it? 2.external...

Hey everyone I'm new to this forum, I must say I am very impressed with everyones mechanical knowledge I've searched here and cummins forum:wrong: for the past three days trying to figure out whats wrong with my pickup and finally decided to ask... I am seeing grey smoke, and a lot, this only...