Recent content by DionysiosA76

Hey guys. I have 6 pristine DT 466 rods with good bushings in them. They mic'd in spec and are ready ship. Looking to sell for $450 Call or text Dion @224-489-889five Thanks!!! Sent from my iPhone using Tapatalk

65,000mi. Replacing with 100% units. Still in truck. Fuel always filtered through Caterpillar 0751 2micron filter. Good used set of injectors. Don't want them to go to waste and have someone core them. *Broken stud on a solenoid where I over tightened it. I flipped the nut on the harness and...

I have one set (6) of rods from a 1994 mechanical DT466. $450 shipped I also have an HX55 from a D13 Volvo. Less than 1 hr run time. Came from a test engine. $550 shipped. Call/Text Dion @ (224) 489-88nineFive Thank you! Sent from my iPhone using Tapatalk

"Remanufactured" because it's converted to brand new. No warping or cracks. T3 foot. $150 Sent from my iPhone using Tapatalk

Looking for drive pressure and low fuel pressure 2 1/16" gauges. Thank you! Sent from my iPhone using Tapatalk

I have just cored 2 International engines. First one was a 1994 mechanical Second was a 2003 E-model For sale: 1-DT466 927 P-Pump -$375 6-DT466E HEUI Injectors -$700 5-DT466 pencil injectors -$50 12-DT rods -$150 for all 2-cams -$200/each 2-blocks -$300/each 2-cranks -$300 for one, $100 for the...

Still trying to sell these damned things. For people unfamiliar, these are 12v rocker arm pedestals that have been machined to accommodate ARP Head Studs. $175 shipped -OR- $100 plus your cores. Dion @ (224) 489-eighty eight95 Thank you. Sent from my iPhone using Tapatalkûi

Complete stock head. Still true, went through completely. Measured out flawless, less than 120,000mi. $650 Big Rapids, MI call/text Dion @ (224) 489-88ninetyfive Thanks? Sent from my iPhone using Tapatalk

$350 shipped 160,000mi Good Shape Call/text Dion @ (224) 489-889five Sent from my iPhone using Tapatalk

So it was late last night and I decided to get motivated to put the main shaft back together. These detents are the most difficult when it's just you in the shop and you are jabbering on the phone with CompD family member hondarider. Sent from my iPhone using Tapatalk

Hey guys, so I have an 06 engine that has been punched .040" oversize to a 4.0556" bore, mains have been drilled and tapped to accept 14mm studs, now I'm running into girdle clearance issues obviously. I do not want to have to purchase the 'Gorilla Girdle' or whatever, looking for alternative...

Machined to allow installation of headstuds. $160, or $100 with exchange of your old ones. (224) 489-88nine5 -Dion

Came from a running engine. Nothing wrong with it. No use for it. $250 plus ride. Text for pictures (224) four89-889five

Bogged it right out of the gate, then poured the fuel on to compensate, resulting in this...

$200 shipped. Someone take them, please. Engine had a top end failure. Dion-2244898895