Recent content by dooishman

I bought a truck recently it looks to be lifted 3-4 inches the drive shaft is bent and is causing vibrations and cause the transfer case to mess up so i bought a used drive shaft from im guessing a stock truck when i go to lengthen the drive shaft should it be a tight fit from transfer case to...

Ready to pull the trigger on this for an 04.5 with smarty s06. Its been years that i had bought a fass sytem had a 98 24v in 2011. My 04.5 has thet lift pump on the filter canister which im told i wont need a sump or draw straw that itll hook up to factory fuel canister is this true?

Looking for following: Good working order 271d transfer case (g56) CCSB drive shaft (g56, 271d) Holsetcheetah/ tater built turbo 62/65 Autometer factory 3rd gen match egt gauge Shifter rubber boot (i can see the carpet)

Looking for used items (hard to buy new) : Holset cheetah turbo or 62/65 tater build turbo Egt autometer factory match gauge Fass fuel system 95gph

I got 4.10s on my 3rd 2005 cummins. Will the ring and pinion from a 2nd gen bolt on to my truck itd be nice to have the 3.54 gears

Busted spider gears on my 3.54 rear axle 1999 dodge am i only limited to axles from 98-99 dodge cummins? Or can i use 12 valve axles as well.

websites? to order ubolts for a 1999 dodge cummins was swapping axles and all the u-bolt clamps are rotted out was wondering if anyone knew where to order them unless i need to go to the dealer went to local auto parts and they didnt help :nail:

Post with price dont really want a brand new one Or pm me

Looking for a good used cheetah holset turbo, ecm, and a black fifth wheel tailgate for a 2005 dodge Cummins 6sp 4door sb 2500

Gonna try my luck here hopefully u guys have these parts. Looking for a working transfer case for g56 Also need the plastic inside fender that covers the turbo/motor from mud/debris (just the right side one) Need the floor cup holder console since it's a stick I think i also need the upper...

Hopefully i got the right place to ask but i got a problem. i have a 2004.5 dodge cummins i bought it had a piston melt down on number four and scarred the side of the chamber. we are about where we are gonna be pulling the motor. So me and my pops and uncle are waiting to put a used cummins...