Recent content by Farmall Power

2003 Dodge 3500,QC,lb. 193k, 6 speed manual, 4wd. 5.9 Cummins diesel. Grizzly locking rear diff, Haisley machine twin disc street,drag clutch (25k ago) s475 over s300 twin turbos, 60hp injectors, arson III cp3 pump, mitsu macanical fuel pump,upgraded clutch hydraulic, updated tie rods, coolant...

I have a S300 on my twin set up and im would like to know what size it is. Cana berson use the ID tag on the turbo to ID it? or dose a person have to take the turbo apart and mesure the wheels, if so how and what part of the wheels do you mesure?

my neightbor has a 97 f-350 with a 7.3 in it. he started it yesterday with the auto start to let it warm up, when he put the key in the ignition to drive away it died and blew the starter fuse. he put in another fuse, it turned over some then blew that fues, he put another one in and it would...

Im debating weather to go with the tru trac LSD from eaton or the Yukon Grizzly locker. any one running eather of them, pros, cons?

I installed a s300 over s475 this week in my truck, I have my smarty on sw9, pod 80%, torq2, rp3, timing 3. There is a lot of lag before the first turbo starts to spool and when it dose it takes it time. I have my edge monitoring boost and ti will go to 40, i also have a boost gauge hooked to...

i have a edge juice with the monitor and really like the monitor part of it verses all the gauges. i finally got a smarty pod the other day. If i leave my edge off can i still use it as a monitor with the smarty? other delima is i have a set of twins on the way, where dose the edge read boost of...

I picked up a s300/s400 twin set up for my 03, will need a new manifold for it, is there a better brand to go with/ flows better, lower egt? also is a stainless steel header worth the extra money for faster spooling?

parting out n-14 cummins. good turbo, manifold, intercooler, heads should be good. engine not running.

Looking for opions on a twin disc clutch for my 03, would like to stay away from a sold hub design, what options are out there and is there certin ones to stay away from. Im planing on 650hp when i get done with what im doing for modes so i want a clutch that is good for at least that.

Few questions i have been trying to answer. I put in 75hp edge injector tips last week in my 03. Few days latter i noticed a little louder then normal valve train and a slite miss( not sure what to call it) Ran the valves a few were off but didnt make much of a differnce. I had my edge juice on...